Giải pháp Sand Loop Màn 344

Step 1: Direct sand to the first rotating gear.

Draw a continuous, sloped line from the top-left sand source, passing under the first small platform, and ending precisely above the first rotating gear.

Sand flows down the drawn line and begins to spin the first gear.

Step 2: Guide sand from the first gear's output to the second rotating gear.

Once sand begins to exit the first gear, draw a second continuous, sloped line starting from the point where the sand drops from the first gear, extending downwards to direct the flow directly onto the second rotating gear.

Sand successfully flows from the first gear, along the second line, and starts to spin the second gear.

Step 3: Fill the cup with sand.

Allow the sand to flow naturally from the second gear into the waiting cup below.

The cup fills completely, and the 'Level Clear' message appears.

The exact length and curvature of the drawn lines.

Cách thích ứng: While precise measurements are not critical, the general trajectory and slope of the lines (two distinct segments guiding sand sequentially through the gears) must be maintained for successful completion. Minor adjustments based on sand flow dynamics may be needed.

Q: How do I get the sand to the first spinning gear?

A: Draw a sloped line from the sand source to guide the sand directly onto the first gear.

Q: My sand is not reaching the second gear after passing the first one.

A: You need to draw a second line. This line should start precisely where the sand exits the first gear and guide it downwards onto the second gear.

Q: The sand seems to get stuck or spill.

A: Ensure your lines are drawn smoothly and are adequately sloped to maintain continuous flow. Avoid creating flat sections where sand can accumulate, and make sure the lines are long enough to contain the sand.