Giải pháp Sand Loop Màn 391

Step 1: Release the initial sand stream.

Tap and drag the top-left rotating platform clockwise (right turn) by approximately 90 degrees.

Sand begins to fall from the top-left section.

Step 2: Guide the initial sand stream into the first collection area.

Tap and drag the bottom-left rotating platform clockwise (right turn) by approximately 90 degrees.

The falling sand is redirected into the bucket-like area below, eventually filling it and releasing the ball.

Step 3: Create a path for the released ball to roll to the right.

Tap and drag the bottom-left rotating platform anti-clockwise (left turn) by approximately 90 degrees, returning it to its original position.

The ball rolls smoothly from the filled area to the right, into a horizontal channel.

Step 4: Form a ramp for the ball to cross a small gap.

Tap and drag the middle-left rotating platform clockwise (right turn) by approximately 90 degrees.

The ball rolls up the newly formed ramp and across the gap.

Step 5: Direct the second stream of sand into the next large gap.

Tap and drag the middle-right rotating platform clockwise (right turn) by approximately 90 degrees.

A new stream of sand falls from the top and is guided into the gap to the right of the ball's current position, filling it.

Step 6: Clear the path for the ball to roll over the newly filled sand gap.

Tap and drag the middle-right rotating platform anti-clockwise (left turn) by approximately 90 degrees, returning it to its original position.

The ball rolls over the filled sand gap to the next section.

Step 7: Direct the third stream of sand into the next gap.

Tap and drag the lower-middle rotating platform anti-clockwise (left turn) by approximately 90 degrees.

A new stream of sand falls and is guided by the platform into the next gap, filling it.

Step 8: Clear the path for the ball to roll over the third filled sand gap.

Tap and drag the lower-middle rotating platform clockwise (right turn) by approximately 90 degrees, returning it to its original position.

The ball rolls over the recently filled sand gap.

Step 9: Direct the final stream of sand into the last major gap.

Tap and drag the bottom-right rotating platform clockwise (right turn) by approximately 90 degrees.

A final stream of sand falls and is guided by the platform into the last large gap, filling it completely.

Step 10: Clear the path for the ball to roll over the final filled sand gap.

Tap and drag the bottom-right rotating platform anti-clockwise (left turn) by approximately 90 degrees, returning it to its original position.

The ball rolls over the final sand-filled gap.

Step 11: Direct the ball into the final exit pipe and bucket.

Tap and drag the last rotating platform (bottom-right, directly before the pipe) clockwise (right turn) by approximately 90 degrees.

The ball rolls into the exit pipe and lands in the collection bucket, completing the level.

Q: How do I know when to rotate a platform?

A: Platforms usually need to be rotated when sand needs to be redirected to fill a gap, or when the ball needs a clear path to roll. Often, a platform is rotated once for sand, and then again (back to a different position) for the ball.

Q: The sand isn't flowing where it's supposed to. What should I do?

A: Check the rotation of all platforms in the sand's path. Even a slight misalignment can cause the sand to spill. Ensure there's a continuous 'pipe' or ramp created by the platforms.

Q: My ball fell off the map. How can I prevent this?

A: Ensure that any gaps are completely filled with sand and that all platforms forming a pathway for the ball are properly aligned *before* the ball reaches that section. Avoid rotating platforms while the ball is directly on them unless it's intended to change its direction.