Giải pháp Sand Loop Màn 204

Step 1: Initiate sand flow.

No operation needed; sand flow automatically starts from the yellow bar at the top.

Sand begins to fall from the top-center.

Step 2: Direct the initial sand stream to the left platform/pipe.

Draw a short, slightly diagonal line (from ~00:03) downwards from the top-right existing pipe section towards the lower-left existing pipe section, causing the sand to deflect left.

The sand hits the drawn line and begins to flow onto the horizontal pipe section on the left.

Step 3: Guide the sand from the left pipe towards the right, into the red bucket's general area.

Draw a horizontal line (from ~00:04) at the far left end of the horizontal pipe section. This acts as a wall, preventing sand from falling off the left side and forcing it to flow right.

Sand accumulates against the new wall and flows along the horizontal pipe towards the right side of the screen.

Step 4: Aim the sand into the opening of the red bucket.

Draw a diagonal line (from ~00:05) downwards, starting from above the red bucket's opening and extending into it, creating a funnel.

Sand flows along this line directly into the red bucket's opening.

Step 5: Ensure all sand enters the red bucket and prevent spillage.

Draw a short horizontal line (from ~00:06) just below the red bucket's opening. This ensures any sand that might overshoot the previous line is caught and directed into the bucket.

All sand is contained within the red bucket, which fills up completely. The 'Level Clear' screen appears.

Q: How do I get the sand to the red bucket efficiently?

A: The key is to draw lines that create a continuous path, first redirecting sand left, then right, and finally funneling it into the bucket while preventing spills.

Q: What's the best way to start directing the sand?

A: Your first line should be a short diagonal one to deflect the initial falling sand onto the horizontal pipe section on the left side of the screen.

Q: How do I stop sand from falling past the red bucket?

A: After guiding sand towards the bucket, draw a short horizontal line just beneath the bucket's opening to create a 'lip' that catches any overflowing sand and directs it in.