Giải pháp Sand Loop Màn 201

Step 1: Start sand flow from the left source towards the top-left container.

At 00:01, draw a line from the top-left sand source to guide sand into the pipe leading to the top-left container.

Sand begins flowing into the top-left container.

Step 2: Start sand flow from the middle source towards the middle container, preparing to push a red block.

At 00:02, draw a line from the middle sand source downwards, leading the sand into the middle container's entrance, passing just over a red block.

Sand flows into the middle container.

Step 3: Start sand flow from the right source to activate the first two yellow switches and open gates for the right-side containers.

At 00:04, draw a line from the right sand source downwards, guiding the sand to hit the upper-right yellow switch (switch 1) and then continue to the lower-right yellow switch (switch 2).

The gate for the top-right container opens at 00:05, and the gate for the bottom-right container opens at 00:07, with sand flowing into both.

Step 4: Use the middle sand stream to push the red block out of the way.

At 00:09, extend the path for the middle sand stream (already flowing) directly into the red block.

The red block is pushed out of the way at 00:10, clearing a new path.

Step 5: Use the sand from the top-left source to activate the final yellow switch and fill the last container.

At 00:11, extend the path for the top-left sand stream (already flowing) through the newly cleared area (where the red block was) to hit the final yellow switch (switch 3).

The final gate opens at 00:13, and sand flows into the last container, leading to level completion.

Q: How do I open the gates for the right-side containers?

A: Guide the sand from the rightmost source to hit the two yellow switches sequentially.

Q: How do I move the red block blocking the path to the final switch?

A: Direct the sand from the middle source to push against the red block once the initial paths are drawn.

Q: Which sand source should be used for the final yellow switch?

A: The sand from the top-left source should be redirected through the path cleared by the red block to activate the final switch.