Sand Loop Level 76 Solution

Step 1: Lower the initial platform to cross the first gap.

Walk onto the pressure plate located near the starting point.

Sand flows into a container, causing the adjacent platform to lower and form a bridge to the other side.

Step 2: Raise the next platform to cross a larger gap.

Push the large rectangular block onto the visible pressure plate.

The block settles on the plate, activating a continuous sand flow that fills a container, raising a platform to jump onto.

Step 3: Create a sand ramp to reach a higher section.

Push the small block positioned near the large sand pile onto the pressure plate.

A large volume of sand is released from the pipe, forming a walkable ramp to ascend.

Step 4: Create a sand bridge to cross the third gap.

Push the available block onto the pressure plate.

Sand flows into a container, creating a solid sand path across the gap.

Step 5: Position a block onto a distant pressure plate using a temporary sand ramp.

Stand on the first pressure plate to activate a temporary sand flow, creating a ramp. Immediately push the nearby block so it slides down this sand ramp onto a second pressure plate.

The block lands on the second pressure plate, activating a new sand flow that fills a container and raises a pillar.

Step 6: Align the final two moving platforms to reach the exit.

Step on the right pressure plate (at 00:46), then the left (at 00:48), then the right again (at 00:50), and finally the left again (at 00:52), observing the platform movements. Adjust as needed until both platforms are positioned correctly.

The two platforms lock into place, creating a continuous bridge to the final exit area.

Step 7: Exit the level.

Walk into the glowing blue portal.

The level clear screen appears, indicating successful completion.

Q: How do I make the first platform move?

A: Stand on the pressure plate (the circular pad on the ground) directly in front of the sand pipe. Your weight will activate the sand flow.

Q: The large block near the middle of the level keeps falling into a pit instead of onto the switch. What am I doing wrong?

A: You need to activate the temporary sand ramp before pushing the block. Stand on the switch to create the sand ramp, and *while still standing on it*, push the block so it slides along the sand onto the next switch.

Q: How do I align the last two platforms to reach the exit?

A: There are two separate pressure plates. Each one controls one of the platforms. You need to step on them strategically (e.g., step on one, then the other, then maybe the first again) to slowly adjust their positions until they form a stable bridge to the exit.