Giải pháp Sand Loop Màn 414

Step 1: Create a primary path for the sand.

Draw a curved line starting from below the sand source, curving downwards and to the right, aiming towards the center of the target container. Extend the line slightly past the container's right edge.

The curved line is fully drawn on the screen (around 00:09).

Step 2: Test the initial path and identify any issues.

Tap the 'Play' button to start the sand simulation.

Sand begins to flow, and it's observed that some sand spills over the right side of the container (around 00:10-00:13).

Step 3: Adjust the drawing to prevent sand spillage.

After the failure, restart the level. Add a short, nearly vertical line segment on the right side of the container's opening, connecting it to the end of the previously drawn curved line, forming a small wall.

The modified drawing, including the new barrier, is complete (around 00:15).

Step 4: Verify the adjusted path and complete the level.

Tap the 'Play' button again to start the sand simulation with the corrected drawing.

Sand flows smoothly into the container without spilling, and the 'Level Cleared!' message appears on screen (around 00:18).

Q: How can I prevent sand from spilling over the right side of the container?

A: You need to add a small vertical barrier or wall on the right side of the container's opening, connected to your main sand-guiding ramp, to ensure all sand enters the container.

Q: What is the correct drawing for the Sand Loop level?

A: Draw a curved ramp leading the sand into the container, and crucially, add a small wall or barrier on the right side of the container's opening to prevent spillage. Refer to the drawing at 00:14 for the successful setup.